Lab 1: Scaling, Averaging and Error Signal Generation Using OP AMPs
This collection of presentations takes viewers through the design processes required to complete Lab 1 in ET 438a. The presentation has four parts. Part 1 describes how to design a scalar circuit using two OP AMPs. The second presentation shows how to design an averaging circuit using both inverting and non-inverting OP AMP circuits, Part three cover how to use a difference amplifier to produce error signal. The final section shows how to simulate sensor inputs using potentiometers and voltage dividers.
Presentation Times:
- Part 1: 9:06
- Part 2: 7:11
- Part 3: 6:37
- Part 4: 8:26
